JCR Metal Ceiling Grilyato Grid Roll Forming Line

JCR Metal Ceiling Grilyato Grid Roll Forming Line 

Pyramid Type Open Cell Grid 

The metal ceiling grilyato roll forming line is mainly used for open cell ceiling grilyato production by roll forming automatically, the whole production is composed of decoiler, leveler, two hydraulic press for punching &cutting, conveyor belt, roll forming machine, run out table electrical control panel, etc.

1.    Open Cell Ceiling Grilyato Production flow:
Decoiler and leveling machine –punching machine—cutting off----transmission strap- roll forming machine—run out table 
2.    Metal Ceiling Grilyato Roll Forming Line Main technical parameter:
1)    Composition 
1.1)    Decoiler                 1000kgs weight capacity                                                                  1 set
1.2)    Leveling machine                                                                                                            1set 
1.3)    Punching machine (hydraulic press) with NC feeder (punching die: 4 sets)                  1set
1.4)    Transmission strap                                                                                                          1set 
1.5)    Roll forming machine     12 Nos,                                                                                     1set
1.6)    Central electrical control: touch screen + PLC                                                                 1set                  
1.7)    Run out table                                                                                                                   1set

2)    Electrical control system
2.1) drive motor: 4kw 
2.2)Transmission reducer: cycloid-pin speed reducer 
2.3)Touch screen: Delta  7 inch.
2.4)PLC: Fatek, Taiwan  
2.5) Frequency convert:     Delta,  4kw 
2.6)Contactor: Schneider 
2.7) Encoder: Omron 
2.8)Power supply: 380V50Hz

3)    Roll forming roller
3.1)Material: CR12 steel, vacuum heat treatment, accurate grinding hard chroming and polish. 
3.2)Main shaft: material:40Cr, tempering, finish turning and grinding. 
4)    Machine body
4.1)It is welding by steel plate, main arch thickness:40mm, secondly arch thickness:40mm.
4.2) Side board thickness: 8mm, bottom plate thickness: 20mm, then milling, side board with blackening treatment.
4.3) Roll forming speed: 0-18m/min 
4.4) Incoming coil width: 200mm(max), thickness: 0.32-0.42mm, material: aluminum 
4.5) Machine size: 15000*850*1100MM, weight: about 3500kgs

4) Finished product: