JCR Ceiling Furring Channel Roll Forming Line
JCR Metal Ceiling Furring Roll Forming Machine
With speed 70m/min
JCR metal ceiling furring roll forming machine is mainly used for ceiling furring mass production with high speed, up to 70m/min. It is composed of decoiler, roll forming machine, hydraulic punching, run out table and electrical control panel. Etc.
1. Metal Ceiling furring roll forming line production flow:
Decoiler – roll forming machine—punch logo & cut-off—run out table
2. Ceiling furring profile drawing:
3. Main technical parameter of
1) Composition of ceiling furring roll forming production line
- Decoiler 1000kgs weight capacity 1 set
- Roll forming machine 11 Nos, (precision & independent 30 guiding pillar type)
- Straightening roller 1 set
- Hydraulic punch logo and Cut-off: 1set
- Central electrical control: touch screen
- Run out table 1set
2. Electrical control system
2.1) drive motor:7.5kw Siemens brand, hydraulic motor: 3.7 kw
2.2)Transmission reducer: WPDS, model: 80, rate:1:10, Chinese brand.
2.3)Touch screen: Fetak, Taiwan 10 inch.
2.5) Frequency convert: Delta, Taiwan 7.5kw
2.6)Contactor: Schneider
2.7) Encoder: 1000 pulse,
2.8)Power supply: 380V50Hz
2.9)Solenoid valve: Rexroth
2.10) Cooling: air conditioning type.
3. Roll forming roller of ceiling stud
3.1)Material: Cr12mov, vacuum heat treatment, accurate grinding hard chroming and polish.
3.2)Main shaft: material:40Cr, tempering, finish turning and grinding.
4. Machine body
4.1)It is welding by steel plate, main arch thickness:40mm, secondly arch thickness:40mm.
4.2) Side board thickness: 10mm, bottom plate thickness: 20mm, side board with blackening treatment.
4.3) Roll forming speed: 0-70m/min
4.4) Incoming coil width: 110.50mm, thickness: 0.45-0.60mm, material: galvanized steel.
4.5) Machine size: 5800*1100*1100MM, weight: about 4500kgs
5. Machine lay out
6. Ceiling furring product:
